Operating instructions

Before use
6
RQT5243
3
2
1
A
B
LOOP
AM ANT
EXT
d
e
HAUT-PARLEURS
SPEAKERS (SB-PM20)(SB-PM22 )
LOW(6
OO
)
HIGH(6
OO
)
R
L
R
L
HAUT-PARLEURS
SPEAKERS (SB-PM20)(SB-PM22)
LOW(6
OO
)
HIGH(6
OO
)
R
L
R
L
d
e
(L)
4
2
1
3
3
(R)
75∞
FM ANT
75∞
FM ANT
Connections
³Do not connect the AC mains lead until all other connections are
complete.
³To prepare the AM loop antenna wire and speaker cords, twist the
vinyl cover tip and pull off.
³For your listening pleasure, keep your speakers from touching the
system.
³These speakers are designed identically so that no left or right
channel orientation is necessary.
1
Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position where radio
signals are received with the least amount of interference.
Note
For best reception :
An FM outdoor antenna is recommended. (á page 7)
2
Connect the AM loop antenna.
After attaching the antenna, turn on the system and tune in a
broadcast station. Then, turn the antenna to the angle of best
reception and least interference.
3
1 Connect the right (R) and left (L) speaker
cords (pin type).
2 Connect the right (R) and left (L) speaker ca-
bles.
Note
³To prevent damage to circuitry, never short-circuit positive (i)
and negative (j) speaker wires.
³Be sure to connect only positive (red) wires to positive (i) ter-
minals and negative (black) wires to negative (j) terminals.
³These speakers do not have magnetic shielding. Do not place
them near televisions, personal computers or other devices
easily influenced by magnetism.
4
Connect the AC mains lead.
Insertion of Connector
Even when the connector is perfectly inserted, depending on the
type of inlet used, the front part of the connector may jut out as
shown in the drawing.
However there is no problem using the unit.
Connector
Approx. 3.5 mm
Appliance inlet
Adhesive
tape
FM indoor
antenna
Adhesive
tape
Black (j)
Antenna holder
AM loop antenna
Red (i)
FM indoor
antenna
To household
mains socket
For United Kingdom
For Australia and N.Z.
(United Kingdom only)
BE SURE TO READ THE CAUTION FOR THE
AC MAINS LEAD ON PAGE 4 BEFORE PRO-
CEEDING TO STEP ]4].
Caution
³Use the speakers only with the recommended sys-
tem.
Failure to do so may lead to damage to the amplifier
and/or the speakers, and may result in the risk of
fire.
Consult a qualified service person if damage has
occurred or if you experience a sudden change in
performance.
³Do not attach these speakers to walls or ceilings.
Note
The included AC mains lead is for use with this unit only. Do not
use it with other equipment.
1-23e.p65 11/9/99, 4:34 PM6