Operating instructions

Preparations
10
RQT5243
AUTO OFF
1
2
3
A
B
CLOCK/TIMER
H/I
TUNE/TIME ADJ
DOWN/∂∂ UP/µµ
CLOCK/TIMER
AUTO OFF
A
B
1
3
2
FWD
POWERH/I
Auto power-off A
When CD or tape is selected as the source.
To save power the unit turns off if it is left unused for four minutes.
Note
This function does not work if the source is tuner or AUX.
Press [AUTO OFF].
“AUTO OFF” is shown on the display.
To cancel
Press [AUTO OFF] again to clear “AUTO OFF” from the display.
For your reference
The setting is maintained even if the unit is turned off. When the unit
is turned on again, “AUTO OFF” is displayed and the unit functions as
described above.
“AUTO OFF” disappears from the display if either tuner or AUX is
selected as the source. It comes on again when you select CD or
tape.
Setting the time B
This is a 24-hour display clock.
This example in the figure shows how to set the time for 18:25.
1
Press [ê/I] to turn the unit on.
The glide panel retracts enabling access to the operation
buttons.
2
Press [CLOCK/TIMER] to select “CLOCK”.
Each time you press the button;
CLOCK>F PLAY>F REC
^-=Original display(}
3
1 (within 7 seconds or so)
Turn [TUNE/TIME ADJ] to the right or left to
show the present time.
2 Press [CLOCK/TIMER] to finish setting the
time.
The display will return to the previous display setting after about
4 seconds.
To display the time
³To check
Press [CLOCK/TIMER] to select “CLOCK”.
The time will be displayed for about 5 seconds and then the display
will return to whatever was previously displayed.
³To display the time continuously [by\remote\control\only]
Press [DISPLAY] to select present time.
Each time you press the button:
Present time_--------)Tape counter
^-----------Original display(---------}
For your reference
If the time has been set, the display will default to present time when
in standby mode.
For United Kingdom
For Australia and N.Z.
1-23e.p65 11/9/99, 4:34 PM10