Operating instructions

Getting started
21
VQT2Z56

≥ Refer to the operating instructions of the hub or router.
≥ You can perform this setup anytime by selecting “Network Easy Setting” in
the Setup menu. (> 40)
≥ You can redo these settings individually using “Network Settings”. (> 40)
≥ Do not use this device to connect to any wireless network for which
you do not have usage rights.
During automatic search in a wireless network environment, wireless
networks (SSID) for which you do not have usage rights may be displayed;
however, using these networks may be regarded as illegal access.
≥ After performing network settings on this unit, the settings (encryption level,
etc.) of the Wireless router (Access point) might change. When you have
trouble getting online on your PC, perform the network settings of your PC
in accordance with the settings of Wireless router (Access point).
≥ Please be aware that connecting to a network without encryption may
result in the content of the communication being illegitimately viewed by a
third party, or the leaking of data such as personal or secret information.
Occasionally, Panasonic may release updated firmware for this
unit that may add or improve the way a feature operates.
These updates are available free of charge.
This unit is capable of checking the firmware automatically
when connected to the Internet via a broadband connection.
When a new firmware version is available, the following screen
is displayed.
To update the firmware
Press [START] > select “To Others” > [OK] > select
“Setup” > [OK] > select “General” > [OK] > select
“Firmware Update” > [OK] > select “Update Now”
If downloading on this unit fails or this unit is not connected to
the Internet, then you can download the latest firmware from
the following website and burn it to a CD-R to update the
firmware.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
To show the firmware version on this unit. (> 41, “System
Information”)
DO NOT DISCONNECT the unit from the AC power or perform
any operation while the update takes place.
After the firmware is installed, “FINISH” will be displayed on the
unit’s display. Unit will restart and the following screen will be
displayed.

≥ Downloading will require several minutes. It may take longer or may not
work properly depending on the connection environment.
≥ If you do not want to check for the latest firmware version, set “Automatic
Update Check” to “Off”. (> 41)
STEP 6:
Reprogramming the
remote control
When other Panasonic products respond to this
remote control
Change “Remote Control” (> 41) on the main unit and the
remote control (the two must match) if you place other
Panasonic products close together and it responds to this
remote control.
To change the code on the main unit.
1 While stopped, press [START].
2 Press [3, 4] to select “To Others” and
press [OK].
3 Press [3, 4] to select “Setup” and press
[OK].
4 Press [3, 4] to select “General” and press
[OK].
5 Press [3, 4] to select “Remote Control”
and press [OK].
6 Press [3, 4] to select the code (1 or 2) and
press [OK].
To change the code on the remote control.
1 While pressing [OK]
Press and hold the number button (1 or 2),
which has the same number you selected in
the step 6 for more than 5 seconds.
2 Press [OK].
Firmware updating
The latest firmware is available.
Please update firmware in Setup.
The firmware has been updated.
Current Installed Version:
x.xx
RETURN
OK
SCBFT800_VQT2Z56_eng.book 21 ページ ２０１０年８月４日 水曜日 午後５時１０分