Operating instructions

6
RQT9594
ENGLISH
[XH75] Front speakers
Preparation
≥ To prevent damage or scratches, lay down a soft cloth to assemble speakers.
≥ For assembly, use a Phillips-head screwdriver (not supplied).
≥ You will need to obtain the appropriate screw eyes to match the walls or
pillars to which they are going to be fastened.
≥ Consult a qualified housing contractor concerning the appropriate
procedure when attaching to a concrete wall or a surface that may not
have strong enough support. Improper attachment may result in
damage to the wall or speakers.
≥ Use a string of less than ‰2.0 mm, which is capable of supporting over
10 kg.
Caution
≥ Do not stand on the base. Be cautious when children are near.
≥ When carrying the speaker, hold the stand and base parts.
step 1 Preparing the speakers
Speaker assembly option
Make sure you have all the indicated components before starting assembly, setup, and connection.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ For optional wall mount, refer to page 20.
2 Bases 8 Screws2 Front speakers 2 Stands (with cable)
1
2
2
1










Slide into the groove.
Tighten securely.
Position the cable
between the ridges.
Leave about 120 mm.
Press into the groove.
Tighten securely.
Insert the wire fully.
i: White
j: Blue line
Push!




Leave about
120 mm.
You can remove and use the
cable from the stand. To reattach
the cable, refer to page 20.
Slide into the
groove.
Press into the groove.
Tighten securely.
Insert the wire fully.
i: White
j: Blue line
Push!
Thread the speaker cable through
the base.
Attach the speaker.
Preventing the speakers from falling
String (not supplied)
Thread from the wall to the speaker and tie tightly.
Speaker (rear)
Screw eye
(not supplied)
Approx.
150 mm
Wall
6
SC-XH70-75 EP_RQT9594-R_eng.book Page 6 Wednesday, December 14, 2011 9:05 AM