User Guide
RQTX0022
8
Simple Setup
∫ Batteries
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 11), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
Radio operations are described mainly with the remote control.
You can alternatively use the corresponding button on the main unit.
§1
[SELECTOR]
§2
[X TUNING W]
§3
[MEMORY]
Up to 30 stations can be set.
step
4
Preparing the remote control
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
≥ Do not use rechargeable type batteries.
Press in and lift up.
Replace the cover.
step
5
Presetting the radio stations
MANUAL SKIP
ENTER
FM
,
,
Numbered
buttons
SELECTOR
TUNING
MEMORY
-TUNE MODE
1
Press [FM]
§1
to select “FM”.
2
Press [6, 5]
§2
to select the frequency.
≥ When performing this step on the main unit, first press
[-TUNE MODE] to select “MANUAL”, and then press
[
X
TUNING
W
] to select the frequency.
To start automatic tuning, press and hold [6, 5]
until the
frequency starts scrolling. Tuning stops when a station is found.
3
While listening to the broadcast
Press [ENTER]
§3
.
4
While the frequency and “PGM” are flashing on the display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W], and then
press [ENTER]
§3
.
Confirming the preset channels
1
Press [FM]
§1
to select “FM”.
2
Press the numbered buttons to select the channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W].
≥ To perform this step on the main
unit, first press [-TUNE MODE] to select “PRESET”, and then
press [X TUNING W] to select the channel.
DISC SFC
TG
D.MIX
MONO
SLP
DISC SFC
TG
D.MIX
MONO
SLP
D
E
AC
P
RG
S
A
Preparing the remote control / Presetting the radio stations
0022En_p03-13.fm Page 8 Tuesday, April 17, 2007 11:34 AM