User Guide

8
RQT8043
RQTX0043
Operating other equipment
Optional connection for set top box Optional connection for set top box
Optional antenna connectionOptional antenna connection
Use the outdoor antenna if radio reception is poor.
FM outdoor antenna
(Using a television antenna)
Rear panel of
this main unit
FM outdoor antenna
(not included)
75 
coaxial cable (not
included)
Antenna plug adaptor (included)
• Disconnect the FM indoor antenna.
• The outdoor antenna should be installed
by a competent technician.
Note
• Disconnect the outdoor antenna when
the unit is not in use.
• Do not use the outdoor antenna during a
lightning storm.
Set top box
(not included)
Television
(not included)
Rear panel of
this main unit
SCART cable
(not included)
SCART cable (not included)
• To listen to the sound from the television, select the appropriate
audio out (example: Monitor) on the television.
Sound from the television
• Press [EXT-IN] (\ page 40, Operations Guide) to select the
“AV” audio input on the remote control.
Optical digital audio cable
(not included)
• Do not bend sharply when
connecting.
You can change the video signal output from the SCART (AV) terminal from “RGB” to either “S-Video” or
“Video” to suit the type of television you are using.
•
Select “S-Video/YPbPr” or “Video/YPbPr” from QUICK SETUP (\ page 5).
•
Set “Video Mode” to “Off” (\ page 29, “HDMI” tab, Operations Guide).
•
This connection will also enable you to play audio from your television through your home theater system.
Refer to “Operating other equipment” (\ page 36, Operations Guide).
•
Do not use the HDMI cable when you use the scart cable for the connection.
Optical-In for 5.1 ch
surround
This unit can decode the
surround signal from the set
top box. Press [EXT-IN] to
select “D-IN” audio input on
the remote control.
• Optical input settings
(\ page 40, Operations
Guide)
RQTX0043-3B_new.indd 8RQTX0043-3B_new.indd 8 4/2/07 1:50:05 PM4/2/07 1:50:05 PM