User Guide

8
RQT7937
Simple setup
Step 3: Connecting the antennas and AC mains lead
Connecting the antennas and AC mains lead
STEP 3
Connect the AC mains lead after all other connections are complete.
For Southeast Asia
AM loop antenna FM indoor antenna AC mains lead
Conserving power
The unit consumes a small amount of power even when it is turned off with [^]. To save power when the unit is not to be used for a long
time, unplug it from the household mains socket. You will need to reset some memory items after plugging in the unit.
OPTICAL
OUT
S-VIDEO
HAUT-PARLEURS
OUT
VIDEO
OUT
SUBWOOFER
OUT
R
L
AUX
HIGH (6Ω) LOW (6Ω)
SPEAKERS (SB-PM91)
FM ANT
AC IN
AM ANT
EXT LOOP
75Ω
For the Middle East and Southeast Asia
For Southeast Asia
For the United Kingdom and Saudi Arabia
AM loop antenna
Stand the antenna up on
its base.
Keep loose antenna cord
away from other wires and
cords.
FM indoor antenna
Fix the other end of the antenna
where reception is best.
Adhesive
tape
AC mains lead
To household mains socket
The remote control
STEP 4
■ Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to flame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which
can damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store batteries in a cool, dark place.
■ Use
Aim at the sensor, avoiding obstacles, at a maximum range of 7 m
directly in front of the unit.
Remote control Batteries
R6/LR6, AA
• Insert so the poles (+ and –)
match those in the remote
control.
• Do not use rechargeable type
batteries.
Simple setup
Step 4: The remote control
Power plug adaptor
Before connecting the AC mains lead, set the voltage.
Voltage Selector
Use a flat-head screwdriver to turn the voltage selector on
the rear panel to the appropriate position for the area in
which this system is used.
If the power supply in your area is 115 V or 120 V, please
set the voltage selector as follows:
• For 115 V: Set to 110 V.
• For 120 V: Set to 127 V.
If the power plug will not fit your socket
Use the power plug adaptor (included).
If it still doesn’t fit, contact an electrical parts distributor for
assistance.
BE SURE TO READ THE CAUTION FOR
THE AC MAINS LEAD ON PAGE 3 BEFORE
CONNECTION.
Insertion of Connector
Even when the connector is
perfectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as shown
in the drawing.
However there is no problem using
the unit.
Appliance inlet
Approx. 3.5 mm
Connector
SC-PM91D EB.indd 8 3/18/2005 2:18:16 PM