Manual

Simple setup
Front speaker assembly
The supplied stands are specially designed for
attachment to Panasonic SB-FS730 or SB-FS930
front speakers. Use only as indicated in this setup.
Preparation
eTo prevent damage or scratches, lay down a soft cloth and perform assembly on it.
• For assembly, use a Phillips-head screwdriver.
• Make sure you have all the indicated components before starting assembly, setup, and connection.
eThere is no difference between the right and left speakers and pipes.
You can use the front speakers without assembling with the stands. In this case, attach the included
rubber pads to the base of the speakers. This prevents vibration from causing the speakers to move
or fall over. Use 3 or 4 pads per speaker.
"If
! Attach the pipes to the bases.
_]_lnsert pipe B.
3 Attach the pipes to the speakers.
Slot the screw head in between the 2 stoppers of the speaker
groove.
Ensure the pipe is fastened on straight by gradually tightening the
right and left screws alternately until fully tightened.
To prevent a short-circuit, do not cover the connection
terminals with the pipe.
OSecure pipe B to the base.
Ensure the screws are securely fastened.
t Washer screws
_ Phillip_s-head screwdriver
(not included)
,_ Assemble the pipes.
_]_Thread the speaker cable from pipe A through pipe B and
the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the pipe, and then pull
the rest of the cable through the base.
Cable
Pipe B
_Join pipe Ato pipe B.
Pipe B Cable
Secure the pipes.
Ensure the screws are securely fastened.
4
5
Stoppers
Connection terminals
Connect the speaker cables.
Rear of the speaker
Secure the speaker cables to the bases.
Bottom of the base