Manual

*Important: If a remote control button does not work when pressed, press the COMBO button
on the remote and try the button again.
To quickly return to a specific tape counter location. Set to see a recording over and over,
Press DISPLAY* during playback to ,,t Press ACTION to display
display the Counter. | MAIN MENU.
2
Press COUNTER 2
RESET at the
desired position to
reset to "0:00:00."
Continue playback, rewind, or
fast forward.
Press STOP.
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
• T: Presentpos_bnmark
V: Zero position mark
• Unit goes into FF or REW mode and stops at
the last pointthe Counter was set to 0:00:00.
• If a blank portion exists on the tape, and
depending on the position of the V mark, the
V mark display may be out of position.
1) Press AV< •
to select '_/CR."
2) Press
ACTION to
display SET
UP VCR
screen.
3
1)Press &V to
select
"REPEAT
PLAY."
2) Press • to
set REPEAT
PLAY "ON" or
"OFF."
Press ACTION twice
to end setup.
O
• Playback repeats when tape end is reached or
unrecorded portion over 30 seconds is detected.
• During playback, you may also press PLAY/
REPEAT repeatedly on the unit to select
REPEAT "ON" or "OFF."
By pressing the CM/ZERO button in Playback mode
you can skip over 1 to 3 minutes of recorded tape in
just a few seconds.
Press CM/ZERO repeatedly to
select skip time in Play mode.
• No indication appears.
!
1_ Pre_ _,-1 rain Skip
1
2nd Press _2 min Skip
3rd Press_3 min Skip
26