Manual

Search System is ...
Each time a recording ismade, an invisible index mark is placedon the tape.
When timer recordings are made, program index and information are also included.
These index marks can be used to access or scan recordings.
Go directly to the desired recording.
_i!_ i!!!¸
Press SEARCH*
in Playback or
Stop mode to
display INDEX
SEARCH screen,
and then press
NUMBER Keysto
select the
recording number.
• To calculate number,
see below.
Press FF or REW
to start search•
Locates end point of recording for continuity.
Press SEARCH twice in Playback
or Stop mode to display
PROGRAM END SEARCH screen
Press FF to
start search.
Example of Program End Search operation,
PLAYBACKDIRECTION
Play begins at PressI=SEARCHbutton _._
search end. To
search forward or FF
back 1 index,
press FF orREW _o_._ _l _8_,_K IM _ z=:=lllBL_N_II
L_VE.S_SEA.C.._W,j while screen left in PressSEARCHIbutton _
displayed (10 sec.). • FF
• To calculate the Index Number
Example 1 :
To _o to rec. 2 from rec, 4, enter 3 and press REW.
Ifsearchexceedsafew secoadsinBLANK atea.
Example 2:
To goto rec.6 fromrec.2, enter4 andpressFF.
NOTE: _ indicates start points of each recording.
O
• Make each entry within 10 seconds, orthe Index
Search mode wig be canceled.
• If Index Search is started very close to an index
mark, that Index mark may notbe cou_te_ }nthe
search.
24
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the _ast few
seconds of the program, then steps.
_==_[ FroOmmI (BLANK)
Press SEARCH button _s_
• If Program End Search is started very
close to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.