Manual

mmm _ld
__..... SELECT
o
_ _ _,_. ACTIONselect "AUDtC
- I I
OUTPUT." HI d5
2) Press SET to
display screen, I _ _
g
select an item
2) Press SET Type of _ Recommended setting
repeatedly for amplifie_ [ IPF'PJI J r_lh,, I
output.{See It°be J _-_'n_ I r_,'_',_'[,I dts
below.) connected
•, \\
OFF: \\
PCM:
protection,) _ PCM _Bitstrearat pCM
• "E , Digital
Bitstr Do)by D)
output, (
PCM: When yc
that doe_decoder. I_t_ tstream*
• "d Make settings
Bitstr connected to (
PCM: in above table.
Select the digital output to be output from the optical
digital audio output connector of the unit.
DO steps 1 and 2 on page 48.
When playing DVDs recorded in
linear PCM of4B kHz/20 b_J24 bit or
more, digital audio converted to 44,1
kHz/f 6 bit or 48 kHz/f6 bit is output.
(Digital OutpL_ of £CM aadio is restricted
to48 kHz/f6 bit or below for copyright
• "Dolby Digital" selections
Bitstream: Do)by Digita_ bitsfream (fab-5.fch} is
output, (Factory preset)
When you have connected a amplifier
that doesn't have a built-in Do)by Digital
•"dts" selections . Make settings according to amplifier
Bitstream: dis bitstream is autput. (Factory preset) connected to opfical audio outpuf as shown
When you have connected a amplifier
select "AUDIO
select an item,
• "LPCM (DVD)" selections
Linear PCM of less than 48 kHz/t6 bit
is OUtput.When playing DVDs recorded
in linear PCM of over 48 kHz/2O bit, (to
digital audio is output. (Factory preset)
that doesn't have a built-in dts decoder,
• "DRC (Dynamic Range Compression)"
selections
OFF: Normal audio range is selected. (Factory
preset)
ON: For dynamic sound even at law volume,
this is useful for latemight listening.
IDa)by D)gita) DVDs on_y],
Press ACTION to redisplay DVD MAINMENU
and go to step 2 to setup another item. Or,
press ACTION three times to exit.
"1 When connecting an amplifier (with an
optical digital input connector) which
does nat contain the Do)by Digital or
dts decoder, be sure to select "PCM?
If"Bitstream" is selected, starting DVD
play may cause such a high level ofnoise
as to be harmful to Four ears and damage
the speakers.
*2 When a dts decoder is connected, please
select "i_itstream" in "dts_' if "PCM" )s
selected, there will be stereo sound.