S P E C F I L E P ro d u c t N u m b e r : PT-TW240 P ro d u c t N a m e : Short-Throw DLP™ Projector As of August 2013. Specifications and appearance are subject to change without notice.
S P E C F I L E Short-Throw DLP ™ Projector PT-TW240 Specifications Main unit Power supply Power consumption DLP™ chip Panel size Display method Pixels Lens Lamp Screen size Brightness* 3 Center-to-corner uniformity* 3 Contrast* 3 Resolution Scanning frequency HDMI RGB YPBPR (YCBCR) Video Optical axis shift Keystone correction range Installation Terminals HDMI IN COMPUTER 1/2 IN R, G, B Y, PB (CB), PR (CR) VIDEO IN MONITOR OUT AUDIO 1 IN AUDIO 2 IN AUDIO OUT SERIAL IN LAN As of August 2013
S P E C F I L E PT-TW240 Short-Throw DLP ™ Projector Built-in speaker Power cord length Cabinet materials Dimensions (W × H × D) Weight Operation noise* 3 Operating temperature Operating humidity Remote control unit Power supply Operation range* 7 Dimensions (W × H × D) Weight 7 × 4 cm Oval x1 output power 8 W (Monaural) 3.0 m (9 ft 10 in) Molded plastic (PC) 288 x 100* 4 x 246* 5 mm (11-11/32 x 3-15/16* 4 x 9-11/16* 5 inches) Approx. 2.5 kg (5.
S P E F C I L E PT-TW240 Short-Throw DLP ™ Projector 77(3-1/32) 91(3-19/32) 100(3-15/16) 42.8 (1-11/16) 48 220 (8-21/32) 246−247 (9-11/16−9-23/32) Dimensions 70.8(2-25/32) 288 (11-11/32) unit : mm (inch) NOTE: This illustration is not drawn to scale.
S P E C F I L E PT-TW240 Short-Throw DLP ™ Projector Standard setting-up position 908– 1,478 (35-3/4–58-3/16) Adjustable in 30-mm (1-3/16-inch) step. unit : mm (inch) ø38 (1-1/2) Upper edge of projected image H L 128 118 (4-21/32) SH (5-1/32) H Screen L Lower edge of projected image Screen 38 (1-1/2) SW L 140 (5-1/2) 176 (6-15/16) 180.
S P E F C I L E PT-TW240 Short-Throw DLP ™ Projector Projection distance for 16:10 aspect ratio screen unit: meters (feet) Projection size [diagonal] 1.14 m / 1.27 m / 45˝ 50˝ 1.52 m / 1.78 m / 2.03 m / 60˝ 70˝ 80˝ 2.29 m / 90˝ 2.54 m / 100˝ 3.05 m / 120˝ 3.81 m / 150˝ 5.08 m / 200˝ 5.72 m / 225˝ Projection distance [L] 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.3 1.7 2.2 2.5 (1.7) (1.8) (2.2) (2.6) (2.9) (3.3) (3.7) (4.4) (5.5) (7.4) (8.3) Height from the edge of screen to center of lens [ H ] -0.
S P E C F I L E PT-TW240 Short-Throw DLP ™ Projector Installable angle Install the projector at an angle within the range shown below. As of August 2013 SFD13M016 +20° • Horizontal direction The projector may be installed at a horizontal angle of 20°. –20° –10° +10° • Vertical direction The projector may be installed at a vertical angle of 10°.
S P E C F I L E PT-TW240 Short-Throw DLP ™ Projector List of compatible signals The signals that can be input to this projector are shown in the table below. Display mode Display resolution (dots)1 NTSC/NTSC4.
S P E F C I L E PT-TW240 Short-Throw DLP ™ Projector Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, commands must be input through communication software, based on the format and satisfying the communication conditions shown below. Pin assignments and signal names 6 1 9 5 No. 1 2 3 4 5 Signal name – TXD RXD – GND Description NC Send data Receive data NC Ground No.
S P E F C I L E PT-TW240 Short-Throw DLP ™ Projector Basic format Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this order. Add parameters according to the details of control. STX Start (1 byte) : C1 C2 C3 Colon (1 byte) : P1 P2 ... Pn Colon (1 byte) ETX End (1 byte) Parameters (undefined length) Command (3 bytes) (Control and/or query commands) * STX and ETX are character chords. STX is 02 and ETX is 03 when expressed in hexadecimal.
S P E C F I L E PT-TW240 Short-Throw DLP ™ Projector Status request commands Command : Parameter QPW Function Main power status Q$S Lamp on status QSH AV mute function status QIN Input signal status QVX:RTMI0 Q$L QTM:0 Projector run time Lamp run time Temperature status Callback 000 001 0 1 2 3 0 1 HD1 RG1 RG2 VID p1p2p3p4p5 p1p2p3p4 p1p2p3p4/p5p6p7p8 (*1) Description Standby On Standby Lamp on control in progress Lamp on Lamp off control in progress Off On HDMI Computer 1 Computer 2 Vid
S P E C F I L E PT-TW240 Short-Throw DLP ™ Projector Notes on projector placement and operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. 1. Never place objects on top of the projector while it is operating. 2. Make sure there is the unobstructed space as shown below or more around the projector’s exhaust openings.
