LCD Projector Operating Instructions

ENGLISH - 35
Settings
PICTURE menu
Depending on the projection environment, you can use
these preset parameter settings to optimise image
projection. Press I H to cycle through the options.
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
You can adjust the brightness of the projected image.
You can adjust the colour saturation of the projected
image. (Available with VIDEO/S-VIDEO/YP
BPR/RGB
movie/DVI movie signals only)
You can adjust the skin tone in the projected image.
(Available with VIDEO/S-VIDEO/YP
BPR/RGB movie/
DVI movie signals only)
You can adjust the sharpness of the projected image.
You can adjust the white balance more properly in red
colour temperature by pressing I H. (Available with
RGB/DVI still signals only)
You can adjust the white balance more properly in green
colour temperature by pressing I H. (Available with
RGB/DVI still signals only)
You can adjust the white balance more properly in blue
colour temperature by pressing I H. (Available with
RGB/DVI still signals only)
PICTURE MODE
STANDARD Setting for a general image
DYNAMIC Bright and sharp setting
BLACKBOARD
Setting for when projecting on
a blackboard
NATURAL
*1
*1. Selectable when sill image is displayed.
Reproduces the original colour
of the image
CINEMA
*2
*2. Selectable when moving image is displayed.
Setting for a cinema type
movie
NOTE:
• It may take for a while until the image stabilised in the
selected mode.
CONTRAST
BRIGHTNESS
Remote control Control panel
See “Navigating through the menu” on page 34.
See “Main menu and Sub-menu” on page 32.
HigherLower
BrighterDarker
COLOR
TINT
SHARPNESS
WHITE BALANCE RED
WHITE BALANCE GREEN
WHITE BALANCE BLUE
DarkerLighter
More
greenish
More
reddish
More
sharp
Less
sharp