LCD Projector Operating Instructions
Table Of Contents
- Important Safety Notice
- Contents
- Precautions with regard to safety
- Read this first
- About Your Projector
- Setting up
- Connections
- Switching the projector on/off
- Projecting an image
- Remote control operation
- Operating range
- Setting up the image position automatically
- Switching the input signal
- Enlarging the centred area
- Capturing an image
- Stopping the projection
- Resetting to the factory default settings
- Projecting an image in INDEX-WINDOW mode
- Using an assigned function
- Projecting 2 different source image at a time
- Using the laser pointer
- Controlling the volume of the speaker
- Menu Navigation
- PICTURE menu
- POSITION menu
- DISPLAY OPTION menu
- PROJECTOR SETUP menu
- SECURITY menu
- NETWORK menu
- TEMP, LAMP and FILTER Indicators
- Care and Replacement
- Troubleshooting
- Technical Information
- Index
Getting Started
Setting up
ENGLISH - 20
J Projector location range
You can determine where to locate the screen and the projector by considering the lens shift possibilities. See
“Positioning the image” on page 26.
Q When the screen position is fixed
Q When the projector position is fixed
NOTE:
• When the projector is located right in front of the screen and the lens shift lever is centred, you will get the best quality of
the projection image.
• When the lens shift lever is at the vertical limit of the shift range, you cannot move the lever to the horizontal limit, likewise
when the lens shift lever is at the horizontal limit of the shift range, you cannot move the lever to the vertical limit.
• When the projector is tilted and you adjust KEYSTONE, the centre of the screen and the lens need to be realigned.
• Do not attempt to pull the lens shift lever hard while adjusting.
H
V
SH
SW
Placement
Centre of lens
Vertical centre of
screen
Projector
Screen
51%
51%
24% 24%
Projector
Shift range