Installation Instructions

21
Using Web Browser (continued)
Contents of mail sent
 Mail with the contents shown below is sent when the e-mail settings have been established.
Intake air temperature :[ 1 degC / 33 degF ]
Optics module temperature :[ 10 degC / 50 degF ]
PROJECTOR RUNTIME 3 H
LAMP1 ECO 400 H
LAMP1 NORMAL 401 H
LAMP2 ECO 401 H
LAMP2 NORMAL 402 H
LAMP1 REMAIN 1600 H
LAMP2 REMAIN 1600 H
-------- Current status --------
MAIN VERSION 0.03
NETWORK VERSION 0.01
LAMP STATUS LAMP1=ON
LAMP2=OFF
INPUT DVI-D
SIGNAL NAME XGA60
SIGNAL FREQUENCY 0.00kHz / 0.00Hz
----- Wired Network conguration -----
DHCP Client OFF
IP address 192.168.11.65
MAC address cc:7e:e7:00:00:00
----- Memo -----
=== Panasonic projector report(CONFIGURE) ===
Projector Type:PT-EX12K
Serial No:12345678
----- E-mail setup data -----
TEMPERATURE WARNING SETUP
MINIMUM TIME at [ 999] minutes interval
INTAKE AIR TEMPERATURE Over [ 35 degC / 95 degF ]
ERROR [ ON ]
LAMP1 RUNTIME [ ON ] at REMAIN [ 1000] H
LAMP1 RUNTIME [ ON ] at REMAIN [ 1500] H
LAMP2 RUNTIME [ ON ] at REMAIN [ 1800] H
LAMP2 RUNTIME [ ON ] at REMAIN [ 2000] H
INTAKE AIR TEMPERATURE [ ON ]
----- check system -----
MAIN CPU BUS [ OK ]
FAN [ FAILED ]
FAN(PANEL INTAKE) [ FAILED ]
FAN(POWER INTAKE/EXHAUST) [ FAILED ]
FAN(MIRROR EXHAUST) [ FAILED ]
FAN(LAMP1 INTAKE) [ FAILED ]
FAN(LAMP2 INTAKE) [ FAILED ]
FAN(PBS INTAKE) [ FAILED ]
INTAKE AIR TEMPERATURE [ OK ]
OPTICS MODULE TEMPERATURE [ OK ]
LAMP1 REMAIN TIME [ OK ]
LAMP2 REMAIN TIME [ OK ]
LAMP1 STATUS [ OK ]
LAMP2 STATUS [ OK ]
SHUTTER [ OK ]
AIR FILTER [ FAILED ]
COVER OPEN [ FAILED ]
(Error code 40 00 00 22 00 00 0f c0)