S P E C F I L E The PT-D6000LS and PT-D6000LK are not equipped with a lens. P ro d u c t N u m b e r : P ro d u c t N a m e : PT-D6000S/D6000K PT-D6000LS/D6000LK DLP ™ Projectors As of February 2009. Specifications subject to change without notice.
S P E C F DLP ™ Projectors I L E PT-D6000S/D6000K/D6000LS/D6000LK Specifications Main Unit Power supply: Power consumption: North America: Europe: North America: Europe: DLP™ chip: Lens: Panel size: Display method: Pixels: PT-D6000S/D6000K: PT-D6000LS/D6000LK: Lamp: Screen size: Brightness* 2 : Center-to-corner uniformity* 2 : Contrast* 2 : Resolution: Scanning frequency: DVI-D: RGB: YPBPR (YCBCR): S-Video/Video: Optical axis shift: Keystone correction range: Installation: DVI-D IN: Termina
S P E C F DLP ™ Projectors I L E PT-D6000S/D6000K/D6000LS/D6000LK RGB 2 IN: R, G, B: D-sub HD 15-pin x 1 R: 0.7 Vp-p, 75 ohms, G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms HD/VD, SYNC: High impedance, TTL (positive/negative), 75 ohms NOTE: HD/SYNC, and VD terminals do not accept tri-level sync signals.
S P E F C I L E PT-D6000S/D6000K/D6000LS/D6000LK DLP ™ Projectors 423 (16-21/32˝) 9 (11/32˝) 77.5 (3-1/16˝) 20 (25/32˝) 155 (6-3/32˝) 175 (6-7/8˝) 17 (21/32˝) unit : mm (inch) NOTE: This illustration is not drawn to scale. The illustration shows the PT-D6000S/D6000K.
E C F DLP ™ Projectors I L E PT-D6000S/D6000K/D6000LS/D6000LK Standard setting-up position (when installed using the ET-PKD56H) H Upper edge of projected image 416– 496 (16-3/8˝– 19-17/32˝) P *2 340– 420 (13-3/8˝– 16-17/32˝) S L *2 Adjustable in 40 mm (1-9/16˝) steps. *1 Projected image *1 When the lens protrudes to the maximum.
S P E C F I DLP ™ Projectors L E PT-D6000S/D6000K/D6000LS/D6000LK Projection distance for 4:3 aspect ratio screen Unit: millimeters Screen size (inch, diagonal) Distance to screen (L) Zoom Fixed-focus Height from the edge of screen to center of lens (H) Zoom lenses Fixedfocus lens* ET-DLE150 Zoom lens Supplied lens ET-DLE250 Zoom lens ET-DLE350 Zoom lens ET-DLE450 Zoom lens min. max. min. max. min. max. min. max. min. max.
S P E C F I L E PT-D6000S/D6000K/D6000LS/D6000LK DLP ™ Projectors Calculation of the projection distance For a screen size different from the above, use the equation below to calculate the projection distance. Aspect ratio 4:3 ET-DLE150 minimum maximum L (mm) = (diagonal screen size in inches) x 28.0 - 54.0 L (mm) = (diagonal screen size in inches) x 40.3 - 49.8 Supplied lens minimum maximum L (mm) = (diagonal screen size in inches) x 37.0 - 65.
S P E C F DLP ™ Projectors I L E PT-D6000S/D6000K/D6000LS/D6000LK List of compatible signals This projector supports RGB signals with horizontal frequencies of 15 to 91 kHz, vertical frequencies of 50 to 85 Hz and up to 150 MHz dot clock. NOTE: The native resolution of this projector is 1,024 x 800 pixels.
S P E F C DLP ™ Projectors I L E PT-D6000S/D6000K/D6000LS/D6000LK Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, commands must be input through communication software, based on the format and satisfying the communication conditions shown below. Pin assignments and signal names No. Signal name Description 1 – NC No.
S P E C F I DLP ™ Projectors L E PT-D6000S/D6000K/D6000LS/D6000LK Cable specifications Projector 1 PC (DTE) NC NC 2 2 3 3 4 NC NC NC NC 6 7 7 8 8 9 4 5 5 6 1 NC NC 9 Control commands * Command : Parameter Function PON POF IIS:DVI IIS:RG1 IIS:RG2 IIS:VID IIS:SVD LPM:0 LPM:1 LPM:2 LPM:3 OSH:0 OSH:1 OFZ:0 OFZ:1 OAS VPM:NAT VPM:STD VPM:DYN VPM:CIN VPM:GRA VXX:DLVI0=+00000 VXX:DLVI0=+00001 VXX:DLVI0=+00002 VXX:DLVI0=+00003 OTE:1 OTE:2 OTE:4 OTE:10 TSD:y1y2y3y4m1m2d1d2w TST:h1
S P E C F I L E PT-D6000S/D6000K/D6000LS/D6000LK DLP ™ Projectors Status asking commands Command : Parameter Q PW Function Main power status Q SH Shutter function status Q FZ Freeze function status Q IN Input signal status Q OS On-screen display status Q ST Q $L:1 Q $L:2 Q SL Projector run time Lamp 1 run time Lamp 2 run time Lamp operation mode status Q LP Lamp power mode status Q PM Picture mode status Q VX:DLVI0 System daylight view status Q TM:0 Q TM:1 Q TM:2 Q GD Q GT Tempe
S P E C F I DLP ™ Projectors L E PT-D6000S/D6000K/D6000LS/D6000LK Notes on Projector Placement and Operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. 1. Never place objects on top of the projector while it is operating. 2. Make sure there is an unobstructed space of 500 mm or more around the projector’s exhaust openings. 3. Do not stack projector units directly on top of one another.
