DLP-Based Projector Operating Instructions

Preparation
About Your Projector
ENGLISH - 13
 Side views
NOTE:
• Switch on the POWER button of the projector body that is located near the terminals before using the control buttons.
• Do not touch the LAN terminal with your bare hands or body, as body parts may have charged static electricity. Failure to do so may
cause malfunctions. Do not touch the metallic parts of LAN terminal and cable.
• Please connect the LAN to indoor devices only.
Auto Cleaning Filter (ACF) compartment (page 32)
POWER button
Switch the projector on/off. (page 19)
AC IN terminal
Connect the power cord to supply
electronic power to the projector.
(page 19)
Air intake port Air intake port
Security lock
Attach the commercial shackle lock, manufactured
by Kensington, to protect your projector.
Compatible with the Kensington MicroSaver
Security System.
S-VIDEO IN
Connect an S-VIDEO signals.
(Mini DIN 4 pin)
VIDEO IN
Connect a video signals.
(BNC)
LAN
Connect a LAN cable for network
connection.
(RJ-45)
RGB 1 IN
Connect an RGB or YPBPR signals.
(3, 4 or 5 wire BNC)
RGB 2 IN
Connect an RGB or YPBPR signals.
(D-SUB 15 pin female)
DVI-D IN
Connect a single link DVI-D signals.
(DVI-D 24 pin)
REMOTE 1 IN/OUT
When two or more main
units are used in the system,
they can be connected and
controlled with wired remote
control cable.
(M3 jack)
REMOTE 2
Connect a cable from an
external control circuit.
(D-sub 9 pin female)
SERIAL IN/SERIAL OUT
Connect an RS-232C cable
from/to a computer.
SDI IN (PT-DZ6710U only)
Connect a cable from a
computer.
(BNC)