DLP-Based Projector Operating Instructions

ENGLISH - 12
Preparation
About Your Projector
 Top, front and bottom view
Projector body
NOTE:
• Do not cover the ventilation openings or place anything within 50 cm (20") of them as this may cause damage or injury.
• While the projector is not in use, keep the projector lens cover attached to protect the lens.
STANDBY(RED)/
STANDBY(RED)/
ON(GREEN)
ON(GREEN)
LAMP
LAMP
TEMP
TEMP
FILTER
FILTER
STANDBY(RED)/STANDBY(RED)/
ON(GREEN) ON(GREEN)
LAMPLAMP TEMPTEMP FILTERFILTER
Indicators
Power indicator
Lamp1 (LAMP1) indicator (page 28)
Lamp2 (LAMP2) indicator (page 28)
Temperature (TEMP) indicator (page 28)
Filter (FILTER) indicator (page 29)
Front leg adjusters
Screw up/down to adjust the
projection angle.
Projection lens
Remote control signal
receptor (page 21)
Focus ring
Lamp unit compartment (page 30)
Air exhaust port
Burglar hook port
Attach a commercial burglar
prevention cable.
Input select buttons
These buttons select the
RGB1, RGB2, DVI-D, VIDEO,
S-VIDEO and SDI
(PT-DZ6710U only) terminals.
(page 19)
POWER ON button
Starts the projection while
in the standby mode.
(page 19)
POWER STANDBY
button
Returns to the standby
mode. (page 20)
AUTO SETUP button
Pressing this button while projecting an image
automatically corrects the picture positioning on
the screen. While the auto setup feature is active,
a message “PROGRESS” appears on the screen.
(page 21)
Remote control signal receptor (page 21)
SHUTTER button
Pressing this button toggles the projector’s
internal mechanical shutter to black out the
projector. (page 22)
MENU button
Displays and clears the main
menu, and returns to the
previous menu when the menu
is displayed. (page 27)
LENS button
This button is used together with
F G I H to adjust focus, zoom
and shift by the projection lens.
(page 19)
Navigation and
ENTER buttons
Navigate through
the menu items
with F G I H,
and activate them
with the ENTER
button. (page 27)