User Guide

Using the REMOTE 2 terminal
41
Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
Pin assignments and control
Be sure to short-circuit Pins and when controlling.
D-Sub 9-pin (female)
external appearance
• The following buttons on the remote control and the operation area of the projector can no longer
be operated when pins and are shorted: POWER button and SHUTTER button.
Neither will it be possible to use the RS232C commands or network functions corresponding to
these functions.
• If you short pin and pin , and also short one of the pins from to and pin , then the
following buttons on the projector operating area and the remote control can no longer be
operated: POWER button, RGB button (RGB1, RGB2 and DVI buttons in case of remote control),
VIDEO button (VIDEO and S-VIDEO buttons in case of remote control) and SHUTTER button.
Neither will it be possible to use the RS232C commands or network functions corresponding to
these functions.
Note
DVI
Example of a control panel layout
Projector set up in a meeting room
Control panel located in a different room
STANDBY
ON
LAMP
Remote terminal
External control
Remote terminal/External control
RGB1 VIDEO
RGB2 S-VIDEO
Names of terminals
GND
POWER
RGB1
RGB2
VIDEO
S-VIDEO
DVI
SHUTTER
RST / SET
Open (H)
Controlled by remote control
OFF
Other
OFF
Short (L)
Controlled by external contact
ON
DVI
S-VIDEO
VIDEO
RGB2
RGB1
ON
GND
Other
Other
Other
Other