Operating Instructions Vacuum Cleaner Model No. MC-E3011 We would recommend that you carefully study these Operating Instructions before attempting to operate the unit and that you note the Important Safety Instructions. Please keep in a safe place with your Authorised Dealer Service booklet. This product complies with the European directives 73/23/EEC and 89/336/EEC.
TABLE OF CONTENTS Page • Caution for AC Mains Lead (UK and Republic of Ireland only) ...................................2 • Important Safety Instructions for the user ....................3 • Cautions .............................................................................3 • Identification of main parts ..............................................4 HOW TO ASSEMBLE YOUR CLEANER A) Handle assembly / Hose assembly / Mains lead storage......................................................................
IMPORTANT SAFETY INSTRUCTIONS FOR THE USER Before using the vacuum cleaner, please observe these basic precautions. WARNING: To reduce the risk of fire, electric shock, or injury: Do not leave the vacuum cleaner plugged into mains socket. Unplug from the socket when not in use and before cleaning the appliance or undertaken maintenance operations.
IDENTIFICATION OF MAIN PARTS A-1) Handle B-2) Cord clip A-4) Upper cord hook A-3) Hose clip B-1) Mains lead Paper dust bag G) Dust bag check indicator A-4) Lower cord hook/Carrying handle C) ON/OFF Switch Dusting brush Dust bag cover Extension wand Clean air filter Cleaning head Furniture guard Crevice nozzle Hose D) Foot pedal (Handle release) HOW TO ASSEMBLE YOUR CLEANER A) HANDLE ASSEMBLY / HOSE ASSEMBLY / MAINS LEAD STORAGE Hook (both side) Upper cord hook Clicks Hose clip Lower cord hook/Ca
HOW TO OPERATE YOUR CLEANER B) MAINS LEAD RELEASE 1) Turn the upper cord hook to release the mains lead. C) ON / OFF SWITCH 2) Fix the mains lead into the cord clip to help secure it during use. To start or stop the vacuum cleaner push the switch button to “ I ” to turn ON and to “ O ” to turn OFF. IMPORTANT: To avoid any possible damage to the mains lead, never run over the cord or allow it to become caught in the beater bar.
F) HOW TO USE THE ACCESSORIES 1) To use the accessories keep the vacuum cleaner in upright position. Hose support 2) Pull out the hose from the rear side of the vacuum cleaner and remove the hose from the hose clip and support. Then connect any accessory as illustrated. When re-install NOTE: When finish using the accessories, re-insert the hose to the suction inlet and re-install the hose into the hose clip and support. And re-install the extension wand with the crevice nozzle setting on the projection.
MAINTENANCE AND SERVICING IMPORTANT NOTE:Before servicing any part, always DISCONNECT THE CLEANER FROM THE MAINS SUPPLY H) HOW TO CHANGE THE DUST BAG 1) Remove dust cover simply pulling it forwards. 2) Grip the cardboard of the dust bag and pull out. 3) Install the dust bag by pressing the cardboard as shown. 4) Press bottom of the dust bag and set it completely inside the dust bag compartment. Make sure all edges of the dust bag are completely inside the bag compartment.
J) BLOCKAGES If your cleaner stops picking up dust, or the dust bag check indicator shows "Full" while the dust bag is still empty, a blockage may have occurred. Remove the hose from the suction inlet, turn the hose right and pull it upwards (Fig. 1). Clear any obstruction from the hose and/or suction inlet using a blunt implement, taking care not to damage the hose. If the obstruction occurs in the suction pipe inlet, it can be removed with care as shown in Fig. 2. Suction inlet Suction pipe inlet Fig.
L) SERVICING AND REPAIRS CAUTION: Before replacing any part DISCONNECT THE CLEANER FROM THE MAINS SUPPLY. Keep screws away from children after removing this cover. We recommend the use of genuine Panasonic replacement parts. To replace any of the following parts, place the vacuum cleaner in the horizontal position by using the foot pedal and turn it over exposing the underside.
M) TROUBLE SHOOTING GUIDE Before contacting your Panasonic service centre, check the following points: NOTE: Failure to correctly maintain your product, for example regular cleaning and unblocking, may result in a charge if referred to a service agent for attention. CAUSE / REMEDY CHECK POINT TROUBLE • Mains plug connection. • Check that the mains plug is connected firmly and mains outlet is ON. • Mains plug fuse. (UK, IRL only) • Check fuse and replace if blown.
Vacuum Cleaner Consumables / Accessories (For UK and Republic of Ireland customers only) DESCRIPTION MC-E3011 Handle AMC95B-XB0AE (BLUE) AMC95B-XB0RE (RED) Handle screw AMC73B-XD00E Exhaust filter (Clean air filter (electrostatic)) AMC38K-XA00E Central filter AMC64H-XB00E Extension wand AMC40P-XB04E Crevice nozzle AMC61R-XB04E Dusting brush AMC88R-XD04E Dust bag (pack of 5 bags) Type U-20E AMC-B1EP Kit of 2 belts AMC95S-XD00E Beater bar assy AMC92S-XD00E NOTE: Specifications are subjec
REMINDER FOR CUSTOMER The model and serial number of this product may be found on the nameplate located at the back of your cleaner. You should note the model and serial number in the spaces provided and retain this book for a future reference. Model Number: ................................................... Serial Number: ................................................... Date Purchased: ................................................. Where Purchased: ..............................................
