Order Number MAC0401005C1 Vacuum Cleaner MC-V414 00 Specifications are subject to change without notice for further improvement. © 2004 PANASONIC CONSUMER ELECTRONICS COMPANY, DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA. All rights reserved. Unauthorized copying and distribution is a violation of law.
MC-V414 00 2
MC-V414 00 1 WIRING DIAGRAM AND DRAWING 1.1.
MC-V414 00 1.2. PICTORIAL DIAGRAM NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or electrical enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
MC-V414 00 2 EXPLODED VIEW AND PARTS LIST 2.1. 2.1.1.
MC-V414 00 2.1.2. Ref. No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 Parts List (Body) Part No.
MC-V414 00 2.2. 2.2.1.
MC-V414 00 2.2.2. Ref. No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 Parts List (Nozzle Housing) Part No.
MC-V414 00 2.3. Packing Material 2.3.1. Exploded View 2.3.2. Parts List Ref. No. Part No.
MC-V414 00 3 REPLACEMENT INSTRUCTIONS 3.1. 3.1.1. Lower Plate 3.3. Removal 3.3.1. 1. Place handle in low position. 2. Turn the vacuum cleaner over exposing the underside. Release the lower plate by pressing the two (2) latches that secure it inward. 3. Separate the lower plate from the vacuum. Agitator Assembly Removal 1. The brushes are not replaceable separately. When the brushes need replacing, the agitator assembly will have to be replaced. 2.
MC-V414 00 3.4. 3.4.1. Nozzle Housing Replacement 3.4.2. Installation 1. Install the nozzle packing, if not already in place, window and handle release assembly in the new nozzle housing. 2. Fit the nozzle around the motor shaft side first, and rotate it into place on the dust container as illustrated. Removal 1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove the belt and agitator assembly as outlined in the respective sections. 3.
MC-V414 00 3.5. 3.5.1. Power Cord Replacement 3.6. Removal 3.6.1. 1. Remove the seven (7) screws that secure the dust cover and remove the dust cover. On / Off Switch Removal 1. Remove the nozzle cover, agitator assembly, belt and nozzle base. 2. Remove the seven (7) screws that secure the dust cover and remove the dust cover. 3. To replace the on-off switch, remove the plastic insert that is mounted over the motor shaft. Lift the motor up and out of the dust compartment.
MC-V414 00 3.7.2. 3.8. Installation 3.8.1. Carbon Brush Replacement Removal 1. Complete brush change on one side before starting on the other side. There are two (2) brushes located on the motor as identified. Remove the brush assembly by using a Phillips head screwdriver to remove the screw that holds the brush holder onto the motor. 1.
