Operating instructions

Problem Cause/solution
Caller information is displayed
lat
e.
R Depending on your service provider/telephone company,
the unit may display the caller’s information at the 2nd
ring or later.
R Move closer to the base unit.
The caller list/incoming phone
num
bers are not edited
automatically.
R The Caller ID number auto edit feature is turned off. Turn
it on and try again (page 20).
R You need to call back the edited number to activate Caller
ID number auto edit.
I cannot dial the phone number
edi
ted in the caller list.
R The phone number you dialed might have been edited
incorrectly (for example, the long distance “1” or the area
code is missing). Edit the phone number with another
pattern (page 25).
Time on the unit has shifted. R Incorrect time information from incoming Caller ID
ch
anges the time. Set the time adjustment to “Manual”
(off) (page 20).
The 2nd caller’s information is
not
displayed during an outside
call.
R In order to use Caller ID, call waiting, or Call Waiting
Caller ID (CWID), you must first contact your service
provider/telephone company and subscribe to the desired
service.
After subscribing, you may need to contact your service
provider/telephone company again to activate this specific
service, even if you already subscribed to both Caller ID
and Call Waiting with Caller ID services (CWID).
Voice mail
Problem Cause/solution
“N
ew Voice Mail” i
s shown
on the handset display. How do
I remove this message from the
display?
R This notification is displayed when your service provider/
telephone company’s voice mail service has recorded a
message for you. Typically you can remove this
notification from the display by listening to the message.
To listen to the message, dial the voice mail number
provided by your service provider/telephone company (for
most cases, this will be your own phone number), and
follow the voice instructions. Depending on your service
provider/telephone company, you may need to remove all
messages from your voice mailbox to remove the
notification. You can also remove this notification by
pressing and holding # until the unit beeps.
For assistance, please visit http://www.panasonic.com/help
31
Useful Information
WP110_(en_en)_0213_ver110.pdf 31 2014/02/17 16:00:21