Operating instructions

– 4 –
What should I do when the
handset does not turn on?
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
How long should I charge new
batteries?
Charge the batteries for about 7 hours.
How long is the battery operating
time?
When you are using fully-charged Ni-MH batteries
(included batteries);
In continuous use: 17 hours max.
In continuous standby mode: 180 hours max.
L It is normal for batteries not to reach full capacity at the
initial charge. Maximum battery performance is
reached after a few complete cycles of charge/
discharge (use).
L Actual battery performance depends on a combination
of how often the handset is in use and how often it is
not in use (standby).
Can I keep the handset on the
base unit when I am not using it?
L Even after the handset is fully charged, the handset
can be left on the base unit without any ill effect on the
batteries.
When should I replace the
batteries?
If the batteries are fully charged until
1 is displayed,
but 3 is displayed after a few calls, replace the
batteries with new ones.
What is a PIN? The PIN is a 4-digit number that must be entered in order
to change certain base unit settings. The default PIN is
“0000”.
What do I need to do to display
caller information?
L You need to subscribe to Caller ID service. Consult
your service provider/telephone company for details.
L The message “You must first subscribe to
Caller ID.” will be displayed until you receive caller
information after subscribing to Caller ID service.
Question Cause & solution
TG7100CX(e-e)_QG.fm Page 4 Thursday, May 11, 2006 8:06 PM