TG6461E_QG(e).fm Page 1 Friday, March 13, 2009 3:08 PM Model No. KX-TG6461E Quick Guide Connections Base unit L Use only the supplied Panasonic AC adaptor. Correct Press plug firmly. Base unit “Click” “Click” Wrong Hook Base unit “Click” (220-240 V AC, 50 Hz) DSL/ADSL filter* (Not supplied) To telephone line Use only the supplied telephone line cord. *For DSL/ADSL service users Important: L If you use a telephone line cord which is not supplied, the unit may not work properly.
TG6461E_QG(e).fm Page 2 Friday, March 13, 2009 3:08 PM Battery installation/Battery charge Charge for about 7 hours. Confirm “Charging” is displayed. Rechargeable Ni-MH ONLY Note: L USE ONLY Ni-MH batteries AAA (R03) size. L Do NOT use Alkaline/Manganese/Ni-Cd batteries. L When the language selection is displayed after installing the batteries for the first time, you can select your desired language. {V}/{^}: Select your desired language.
TG6461E_QG(e).fm Page 3 Friday, March 13, 2009 3:08 PM Date and time (Handset) 1 2 3 4 5 6 7 8 (middle soft key) {V}/{^}: “Handset Setup” i M {V}/{^}: “Time Settings” i M {V}/{^}: “Set Date/Time” i M Enter the current date, month, and year. i M Enter the current hour and minute. M i {ih} Basic operations Making/Answering calls (Base unit/Handset) Making calls Base unit: Dial the phone number. i Lift the corded handset, or press {s}. Handset: Dial the phone number.
TG6461E_QG(e).fm Page 4 Friday, March 13, 2009 3:08 PM Basic operations Phonebook (Base unit/Handset) Adding entries 1 Proceed with the operation for your unit. Base unit: n (left soft key) i 8 i {V}/{^}: “New Entry” i M Handset: n (left soft key) i 8 i {V}/{^}: “New Entry” iM 2 Enter the party’s name (16 characters max.). i M L You can change the character entry mode by pressing /. L To enter a name, see the character table in the operating instructions. 3 Enter the party’s phone number (24 digits max.
TG6461E_QG(e).fm Page 5 Friday, March 13, 2009 3:08 PM Frequently asked questions Question Cause/solution Can I keep the handset on the base unit or charger when I am not using it? L Even after the handset is fully charged, the handset can be left on the charger without any ill effect on the batteries. When should I replace the batteries? L If the batteries are fully charged until & is displayed, but ) is displayed after a few calls, replace the batteries with new ones.
TG6461E_QG(e).fm Page 6 Friday, March 13, 2009 3:08 PM Registering a handset to the base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit, re-register the handset. Handset 1 8 (middle soft key) 2 {V}/{^}: “Handset Setup” i M 3 {V}/{^}: “Register H.set” i M M Base unit Press and hold {x} for about 5 seconds, until the registration tone sounds. L The next step must be completed within 90 seconds.
TG6461E_QG(e).fm Page 7 Friday, March 13, 2009 3:08 PM Optional service (Caller ID) If you subscribe to a Caller ID service, 012345 caller information will be displayed when a call is received, or when viewing missed calls. Sales and support information Customer Care Centre L For customers within the U.K.: 0844 844 3898 L For customers within the Republic of Ireland: 01289 8333 L Visit our website for product information: www.panasonic.co.uk L E-mail: customer.care@panasonic.co.
TG6461E_QG(e).fm Page 8 Friday, March 13, 2009 3:08 PM IMPORTANT If you have any problems operating this product, please try the following: 1 Reconnect AC adaptor. 2 Use supplied telephone line cord. 3 Use rechargeable Ni-MH batteries. (Alkaline batteries CANNOT be used.) Refer to Troubleshooting in Operating Instructions and FAQs in this Quick Guide. If you still have any problems, please call the Panasonic DECT Helpline 0844 844 3898 (U.K.
