Operating instructions

Chapter 6Useful Information
77
Problem
While programming or searching, the
unit starts to ring and stops the
program/search.
The unit does not display the caller’s
phone numbers.
The display goes to the stand-by mode
while viewing the Caller List or
phonebook.
does not function.
The paged handset does not answer.
While using the intercom, two tones
sound.
The unit misdials when connected to a
PBX.
You cannot register the handset in the
base unit.
Remedy
•To answer the call, press . Start again from
the beginning after hanging up.
•Other telephone equipment may be interfering with
your telephone. Disconnect it. Try again.
•Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
•Do not pause for over 60 seconds while searching.
•The handset is too far from the base unit.
•The handset is engaged in an outside call or is
viewing the Caller List or phonebook. Wait until the in
use indicator ( ) light goes out.
•The handset is not in the same radio area.
•The handset is engaged in an outside call.
•The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p. 64).
•Acall is being received. To answer, press
twice.
•Check the pause function (p. 39).
•The base unit has registered a maximum of
6 handsets or the handset has registered a maximum
of 4 base units.
•There is interference from other electrical units.
Locate the handset and base unit away from them.
•You must finish registration within 1 minute after the
ringer tone sounds, or programming will be cancelled
(p. 64).
KX-TCD965EC-6(74~84) 99.9.27 7:59 PM Page 77