Operating instructions

Conference
During a call using the handset, you can make an intercom call to another handset and then combine
the calls together to establish a conference call between handsets registered to the same base unit.
73
Chapter 5Multi-Unit User Operations
3 Handset 1:
Press to establish a conference call.
4 Handset 1 or 2:
Press to hang up the conference
call.
3
Setting the Call Waiting Tone
If an incoming call has been received during an intercom between handsets, a call waiting tone
sounds. You can choose whether or not this tone will sound. The factory preset is ON.
1 Handset 1:
During a call, press . Then enter
the desired handset number.
•The call is put on hold.
•If there is no answer, press to
return to the call.
2 Handset 2:
When the unit rings, press to
answer.
INT
INT
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Handset”.
5 Press OKH.
6 Press G or F until the arrow points to
“Call Waiting”.
F
7 Press OKH.
•The current setting is at the arrow.
8 Press G or F to select ON or OFF.
9 Press OKH.
•Aconfirmation tone sounds.
•The display will return to “Call
Waiting”. To return to the stand-by
mode, press or wait for 60 seconds.
C
•You can exit the programming mode any time
by pressing .
C
H
Call Waiting
Range Alarm
Battery Alarm
KX-TCD965EC-5(63~73) 99.9.27 7:58 PM Page 73