Operating instructions

68
Bell Selection
Selecting specified handset(s)
You can choose which handset(s) you want to ring.
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Base”.
5 Press OKH.
•“Input Command” is displayed.
6 Press .
7 Enter the base unit password (p. 45).
•The current setting is displayed.
1: All handsets
2: Specified handset(s)
3: First handset
8 Press .
•The current registered handset number(s)
is/are displayed.
2
1
F
There are three choices for bell selection.
When a call is being received:
— all handsets ring. “All handsets”
— the selected handset(s) ring(s). “Specified handset(s)”
— the selected handset rings first, then if it does not answer, all other handsets will ring. “First handset”
The factory preset is “All handsets”. To change the bell selection, program as follows.
9 Enter the handset number(s) you want to
ring.
•The selected handset number(s) flash(es).
•If you misdial, press the number(s) again.
10 Press OKH.
•Aconfirmation tone sounds.
•The display will return to “Setting
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
C
•You can exit the programming mode any time
by pressing .
C
Input Command
1 2-123456
KX-TCD965EC-5(63~73) 99.9.27 7:58 PM Page 68