Operating instructions

66
Registration
Cancelling a Handset
Each handset can cancel itself or another handset.
Cancelling a base unit
If another handset is out of range and/or its power is OFF when “Cancelling a Handset”, the previous
base unit number will still remain in the cancelled handset. Therefore, you need to cancel the base
unit registered in the cancelled handset.
1 Press .
2 Press G or F until the arrow points to
“Program”, then press
OKH.
3 Press G or F until the arrow points to
“Registration”, then press
OKH.
4 Press G or F until the arrow points to
“Cancel Base”, then press
OKH.
•“Enter H/set PIN” is displayed.
5 Enter the handset password (p. 44).
•Registered base unit(s) is(are) displayed.
F
7 Enter the handset number(s) you want to
cancel.
•The selected handset number(s) flash(es).
•If you misdial, press the number(s) again.
8 Press OKH.
•Aconfirmation tone sounds.
•The display will return to “Setting
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
C
6 Press G or F until the arrow points to
the base unit(s) you want to cancel, then
press
OKH.
•“ ” marks the selected base unit.
7 Press OKH.
8 Press G or F to select “YES”, then
press
OKH.
9 Press OKH.
•Aconfirmation tone sounds and
“CLEARED” is displayed.
•The display will return to “Cancel
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
C
•You can exit the programming mode any time
by pressing .
C
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Base”, then press
OKH.
•“Input Command” is displayed.
5 Press .
6 Enter the base unit password (p. 45).
•The current registered handset number(s)
is/are displayed.
7
F
Input Command
7 123456
KX-TCD965EC-5(63~73) 99.9.27 7:58 PM Page 66