Operating instructions

53
Chapter 3 Cordless Telephone (Advanced Operations)
On the base unit
This function enables the base unit to clear the following settings at one time. They will return to their
initial settings.
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Base”.
5 Press OKH.
•“Input Command” is displayed.
6 Press .
7 Enter the base unit password (p. 45).
0
F
8 Press OKH.
•A confirmation tone sounds.
•The display will return to “Setting
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
C
•You can exit the programming mode any time
by pressing .
C
Bell selection All handsets
Dialling mode Tone
Earth/time break recall Time break recall
Pause timing 3 seconds
Call restricted All clear
handset(s)
Function
Initial setting
Call restriction All clear
number(s)
Base unit password 0000
Base unit ringer volume 2 (MEDIUM)
Base unit ringer pattern 1
Function
Initial setting
Input Command
------------
KX-TCD965EC-3(42~53) 99.9.27 8:02 PM Page 53