Operating instructions

Chapter 2 Cordless Telephone (Basic Operations)
39
How to Use the Pause Feature
(For Analogue PBX Line/Long Distance Service Users)
We recommend you insert “Pause” if a pause is required for dialling with a PBX or to access a long
distance service.
H
Pause
Go Back
Ex. Line access number (PBX)
#
Press .
$ Press and press OKH to select “Pause”.
% Enter a phone number.
F
9
9
Special Features
•Selecting “Pause” creates a pause. “P” is displayed.
This prevents misdialling when you redial or dial a stored number.
•Selecting “Pause” more than once increases the length of the pause between numbers.
9
9P1234567
1 Press .
2 Press G or F until the arrow points to
“Program”, then press
OKH.
3 Press G or F until the arrow points to
“Setting Base”, then press
OKH.
•“Input Command” is displayed.
4 Press .
5 Enter the base unit password (p. 45).
•The factory preset is 0000.
6 Press .
•The current timing is displayed.
1: 3 seconds 2: 5 seconds
3
3
F
7 To select 5 seconds, press .
OR
To select 3 seconds, press .
8 Press OKH.
•Aconfirmation tone sounds.
•The display will return to “Setting
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
C
1
2
Setting the pause timing
You can set the pause timing to 3 seconds or 5 seconds, depending on to your PBX requirements.
The factory preset is 3 seconds.
Make sure that the power is ON (p. 14) and the unit is in the stand-by mode.
•If 5 beeps sound in step 5, the entered
password is incorrect. Enter the correct
password.
•You can exit the programming mode any time
by pressing .
C
KX-TCD965EC-2(26~41) 99.9.27 8:03 PM Page 39