Operating instructions

26
00-00-00
To dial after confirming the
entered number
1 Enter a phone number.
•The entered number is displayed.
•If you misdial, press
I. Digits are erased
from the right.
•To cancel, press I firmly.
•If your line has rotary or pulse service, any
access numbers entered after pressing
will not be included when dialling.
2 Press .
•“ ” is displayed.
•After a few seconds, the display will start
showing the length of the call.
3 To hang up, press or place the
handset on the base unit.
•The handset will return to the stand-by
mode.
Making Calls
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
F or G to select the
desired level.
•The display shows the volume level.
•After a few seconds, the display will return to
the length of the call.
OR
In the stand-by mode, proceed as follows.
1 Press .
2 Press G or F until the arrow points to
“Program”, then press
OKH.
3 Press G or F until the arrow points to
“Receiver Volume”, then press
OKH.
4 Press F or G to select the desired
level.
5 Press OKH.
•The display will return to “Receiver
Volume”. To return to the stand-by mode,
press or wait for 60 seconds.
C
F
Make sure that the power is ON (p. 14).
1 Press .
•“ ” is displayed.
2 Dial a phone number.
•The dialled number is displayed.
•After a few seconds, the display will start
showing the length of the call.
•If “ ” flashes and an alarm tone sounds
after pressing , move closer to the
base unit. Then try again.
•You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 51).
3 To hang up, press or place the
handset on the base unit.
•The handset will return to the stand-by
mode.
12345678
Ex. Low is selected.
Receiver Volume
LOW 1 HIGH
KX-TCD965EC-2(26~41) 99.9.27 8:03 PM Page 26