Operating instructions

25
Chapter 1 Preparation
Setting the VOX SENS Function
The VOX SENS function is preset is 1 (HIGH). If the unit continues to operate after a caller hangs up
or there are long pauses between or after messages, set to 2 (LOW).
1 Press .
2 Press
GG
or
FF
until the arrow points to
“Program”, then press OK
HH
.
3 Press
GG
or
FF
until the arrow points to
“Setting Base”, then press OK
HH
.
•“Input Command” is displayed.
4 Press .
•“Remote Operation” is displayed on
the handset.
•“
P
” is displayed on the base unit.
F
5 Press .
•The current setting, “1” or “2”, is displayed
on the base unit.
6 To set to LOW, press .
OR
To set to HIGH, press .
•The setting is displayed.
7 Press OK
HH
.
•You can exit the programming mode any time
by pressing .
C
1
2
7
Setting the Greeting Monitor Function
When your greeting message is being played to the caller, you can listen to it through the base unit
speaker. To listen to your greeting, set to 2 (ON). The factory preset is 1 (OFF).
1 Press .
2 Press
GG
or
FF
until the arrow points to
“Program”, then press OK
HH
.
3 Press
GG
or
FF
until the arrow points to
“Setting Base”, then press OK
HH
.
•“Input Command” is displayed.
4 Press .
•“Remote Operation” is displayed on
the handset.
•“
P
” is displayed on the base unit.
F
5 Press .
•The current setting, “1” or “2”, is displayed
on the base unit.
6 To set to ON, press .
OR
To set to OFF, press .
•The setting is displayed.
7 Press OK
HH
.
•You can exit the programming mode any time
by pressing .
C
1
2
4
KX-TCD965EC-1(2~25) 99.9.27 8:05 PM Page 25