Operating instructions

17
Chapter 1 Preparation
Selecting the Base Unit Ringer Volume/Pattern
You can program the desired base unit ringer volume and pattern.
Make sure that the power is ON (p. 14) and the unit is in the stand-by mode.
Ringer volume
4 levels (HIGH, MEDIUM, LOW, OFF) are
available. The factory preset is MEDIUM. When
set to OFF, the base unit will not ring.
1 Press .
2 Press
GG
or
FF
until the arrow points to
“Program”, then press OK
HH
.
3 Press
GG
or
FF
until the arrow points to
“Setting Base”, then press OK
HH
.
•“Input Command” is displayed.
4 Press TWICE.
•The current volume is displayed.
1: LOW 2: MEDIUM 3: HIGH 0: OFF
6 Press the desired volume level , ,
or .
•Each time you press a button, the selected
volume is displayed and rings.
7 Press OK
HH
.
•Aconfirmation tone sounds.
•The display will return to “Setting
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
C
0
3
2
1
2
F
Ringer pattern
You can program the desired base unit ringer
pattern (6 patterns). The factory preset is
pattern 1.
1 Press .
2 Press
GG
or
FF
until the arrow points to
“Program”, then press OK
HH
.
3 Press
GG
or
FF
until the arrow points to
“Setting Base”, then press OK
HH
.
•“Input Command” is displayed.
4 Press then .
•The current ringer pattern is displayed.
5 Press the desired ringer pattern
through .
•Each time you press a button, the selected
ringer pattern is displayed and sounds.
6 Press OK
HH
.
•Aconfirmation tone sounds.
•The display will return to “Setting
Base”. To return to the stand-by mode,
press or wait for 60 seconds.
•You can exit the programming mode any time
by pressing .
C
C
6
1
3
2
F
KX-TCD965EC-1(2~25) 99.9.27 8:05 PM Page 17