Operating instructions

16
Ringer Volume
LOW HIGH
Settings
Selecting the Handset Ringer Volume/Pattern
You can program the desired handset ringer volume and pattern.
Make sure that the power is ON (p. 14) and the unit is in the stand-by mode.
•You can press to go to the next menu
instead of pressing G.
•You can exit the programming mode any time
by pressing .
C
F
Ringer volume
7 levels are available. The lowest level is 1. The
highest level is 6. The factory preset is 3. When
set to OFF, the handset will not ring.
1 Press .
2 Press G or F until the arrow points to
“Program”, then press OK
H.
3 Press G or F until the arrow points to
“Setting Handset”, then press
OKH.
4 Press G or F until the arrow points to
“Ringer Volume”, then press OK
H.
•The current volume is displayed and rings.
5 Press G or F to select the desired
level.
•Each time you press a button, the selected
volume is displayed and rings.
F
Ringer pattern
You can program the desired handset ringer
pattern (6 patterns). The factory preset is
pattern 1.
1 Follow steps 1 to 3 of the ringer volume
procedure.
2 Press G or F until the arrow points to
“Ringer Pattern”.
3 Press OKH.
•The current ringer pattern is at the arrow
and rings.
4 Press G or F to select the desired
pattern.
•Each time you press a button, the selected
ringer pattern sounds.
5 Press OKH.
•Aconfirmation tone sounds.
•The display will return to “Ringer
Pattern”. To return to the stand-by
mode, press or wait for 60 seconds.
C
6 Press OKH.
•Aconfirmation tone sounds.
•The display will return to “Ringer
Volume”. To return to the stand-by mode,
press or wait for 60 seconds.
•When set to OFF, “Ringer Off” will be
displayed.
C
•To set to OFF, erase “ ” by pressing G
until “OFF” is displayed.
Ringer Pattern
H
Ringer 1
Ringer 2
KX-TCD965EC-1(2~25) 99.9.27 8:05 PM Page 16