Operating instructions

57
Chapter 5
Useful Information
Problem
The handset does not ring.
The base unit does not ring.
You cannot program function items such
as the dialling mode.
You cannot store a name and phone
number in the phonebook.
While programming or searching, the
unit starts to ring and stops the
program/search.
The unit does not display the caller’s
phone numbers.
The display goes to the stand-by mode
while viewing the Caller List or
phonebook.
does not function.
You cannot redial.
Remedy
•Turn the power ON (p.12).
•The ringer is set to OFF.Select the desired volume
level (p.14).
•The ringer is set to OFF.Set to HIGH, MEDIUM or
LOW (p.15).
•Programming is not possible while the unit is in the
talk or intercom mode.
•Do not pause for over 60 seconds while
programming.
• You cannot store a name and phone number while
the unit is in the talk or intercom mode.
• Do not pause for over 60 seconds while storing.
• To answer the call, press .Start again from
the beginning after hanging up.
• Other telephone equipment may be interfering with
your phone.Disconnect it.Try again.
• Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information.Telephone line noise may be affecting
the Caller ID information.
• Do not pause for over 60 seconds while searching.
• The handset is too far from the base unit.
• The handset is engaged in an outside call or is
viewing the Caller List or phonebook.Wait until the in
use indicator ( ) light goes out.
• Access numbers entered after pressing will
not be included when redialling.
• If the last number dialled was more than 24 digits
long, the number will not be redialled.
KX-TCD955EC(056~064) 99.6.16 5:25 PM Page 57