Operating instructions

Chapter 4
45
Multi-Unit User Operations
Registration
Registering a Handset in the Base Unit
You must register the handset in the base unit before use.
1 Handset:
Press .
2 Press G or F until the arrow points to
“Program”, then press
OKH.
3 Base unit where handset is to be
registered:
Press and hold on the base unit
for more than 10 seconds until the in
use indicator ( ) lights and a
confirmation tone sounds.
4 Handset:
Press G or F until the arrow points to
“Registration”, then press
OKH.
5 Press G or F until the arrow points to
“Register H/set”, then press
OKH.
•The available base unit numbers are
displayed.
6 Press G or F to select the desired
base unit number 1 to 4, then press
OKH.
•The number is assigned as the base unit
number for the handset.
F
•Charge the optional handset batteries for about 4 hours before initial use.
•Make sure that the power is ON (p.12) and the unit is in the stand-by mode.
•Register the handset number within 1 minute.If not registered within 1 minute, press on the
handset to cancel the programming mode.Then start again from step 1.
C
7 Enter the base unit password (p. 35).
8 Press OKH.
•“Please Wait...” is displayed, then
a confirmation tone sounds.
•The handset will return to the stand-by
mode.The current connected base unit
number will be displayed.
•The in use indicator ( ) on the base
unit will go out.
•To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
•You can exit the programming mode any time
by pressing .
•The base unit number which the handset is
currently in contact with can be displayed in
the stand-by mode (p. 50).Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
C
0 New Calls
Base 2
Please Wait...
Enter Base PIN
:
—
KX-TCD955EC(038~047) 99.7.15 2:50 PM Page 45