Operating instructions

43
Chapter 3
Advanced Operations
On the base unit
This function enables the base unit to clear the following settings at one time.They will return to their
initial settings.
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Base”.
5 Press OKH.
•“Input Command” is displayed.
6 Press .
7 Enter the base unit password (p. 35).
0
F
8 Press OKH.
•A confirmation tone sounds.
•The display will return to “Setting
Base”.To return to the stand-by mode,
press or wait for 60 seconds.
C
•You can exit the programming mode any time
by pressing .
C
Input Command
------------
Call restricted All clear
handset(s)
Call restriction All clear
number(s)
Base unit password 0000
Base unit ringer volume 2 (MEDIUM)
Bell selection All handsets
Dialling mode Tone
Earth/time break recall Time break recall
Pause timing 3 seconds
Function Initial setting Function Initial setting
KX-TCD955EC(038~047) 99.6.16 5:24 PM Page 43