Operating instructions

35
Chapter 3
Advanced Operations
On the base unit
You can program a 4-digit password.The factory preset is 0000.Changing the password may prevent
the unauthorised use of your unit by another person.
You need to enter this password when using the following functions:
Once you have programmed the password,
you cannot confirm it.We recommend you
write down the password.If you forget it,
please consult your nearest Panasonic
Service Centre.
—Registering a handset in the base unit
(p.45)
—Cancelling a handset (p.47)
—Setting the bell selection (p.48)
8 Enter the new 4-digit password TWICE.
•A confirmation tone sounds.
•The display will return to “Setting
Base”.To return to the stand-by mode,
press or wait for 60 seconds.
C
—Setting the dialling mode (p.13)
—Setting the pause timing (p.28)
—Setting the earth/time break recall mode
(p.31)
—Setting the call restriction (p.38)
—Clearing the settings of the base unit memory
(p.43)
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Base”.
5 Press OKH.
•“Input Command” is displayed.
6 Press .
7 Enter the current base unit password.
•The factory preset is 0000.
5
F
•If 5 beeps sound in step 7, the entered
password is incorrect.Enter the correct
password.
•You can exit the programming mode any time
by pressing .
C
Input Command
5
----
Input Command
5
---- ----
KX-TCD955EC(032~037) 99.6.16 5:24 PM Page 35