Operating instructions

34
Setting the Password
On the handset
You can program a 4-digit password.The factory preset is 0000.Changing the password may prevent
the unauthorised use of your unit by another person.
You need to enter this password when using the following functions:
—Setting the call prohibition (p.37)
—Clearing the settings in handset memory (p.42)
—Cancelling a base unit (p.47)
1 Press .
2 Press G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Change Hset PIN”.
5 Press OKH.
6 Enter the current handset password.
•The factory preset is 0000.
F
7 Enter the new 4-digit password TWICE.
•If you misdial, press I.Digits are erased
from the right.To erase all digits, press I
firmly.
•If 5 beeps sound in step 6, the entered
password is incorrect.Enter the correct
password.
•You can exit the programming mode any time
by pressing .
C
Once you have programmed the password,
you cannot confirm it.We recommend you
write down the password.If you forget it,
please consult your nearest Panasonic
Service Centre.
•A confirmation tone sounds.
•The display will return to “Change
Hset PIN”.To return to the stand-by
mode, press or wait for 60 seconds.
C
Enter New PIN
12345678900:
----
Verify New PIN
12345678900:
----
1st
2nd
Enter Old PIN
12345678900:
----
KX-TCD955EC(032~037) 99.6.16 5:24 PM Page 34