Operating instructions

To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
F or G to select the
desired level.
•The display shows the volume level.
•After a few seconds, the display will return to
the length of the call.
OR
In the stand-by mode, proceed as follows.
1 Press .
2 Press G or F until the arrow points to
“Program”, then press
OKH.
3 Press G or F until the arrow points to
“Receiver Volume”, then press
OKH.
4 Press F or G to select the desired
level.
5 Press OKH.
•The display will return to “Receiver
Volume”.To return to the stand-by
mode, press or wait for 60 seconds.
C
F
Receiver Volume
LOW HIGH
16
00-00-00
To dial after confirming the
entered number
1 Enter a phone number.
•The entered number is displayed.
•If you misdial, press I.Digits are erased
from the right.
•To cancel, press I firmly.
•If your line has rotary or pulse service, any
access numbers entered after pressing
will not be included when dialling.
2 Press .
•“ ” is displayed.
•After a few seconds, the display will start
showing the length of the call.
3 To hang up, press or place the
handset on the base unit.
•The handset will return to the stand-by
mode.
Making Calls
Make sure that the power is ON (p. 12).
1 Press .
•“ ” is displayed.
2 Dial a phone number.
•The dialled number is displayed.
•After a few seconds, the display will start
showing the length of the call.
•If “ ”flashes and an alarm tone sounds
after pressing , move closer to the
base unit.Then try again.
•You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p.41).
3 To hang up, press or place the
handset on the base unit.
•The handset will return to the stand-by
mode.
Ex.LOW is selected.
12345678
KX-TCD955EC(016~023) 99.6.16 7:01 PM Page 16