Operating instructions

Chapter 1
Preparation
13
Selecting the Dialling Mode
You can program the dialling mode to tone or pulse.If you have touch tone service, set to tone.If
rotary or pulse service is used, set to pulse.The factory preset is tone.
Make sure that the power is ON (p. 12) and the unit is in the stand-by mode.
10 Press OKH.
•A confirmation tone sounds.
•The display will return to “Setting
Base”.To return to the stand-by mode,
press or wait for 60 seconds.
C
1 Press .
2
Press
G or F until the arrow points to
“Program”.
3 Press OKH.
4 Press G or F until the arrow points to
“Setting Base”.
5 Press OKH.
•“Input Command” is displayed.
6 Press .
7 Enter the base unit password.
•The factory preset is 0000.To change the
base unit password, see page 35.
8 Press .
•The current mode is displayed.
1: Tone 2: Pulse
9 To select Pulse, press .
OR
To select Tone, press .
1
2
1
3
F
•If 5 beeps sound in step 7, the entered
password is incorrect.Enter the correct
password.
•You can exit the programming mode any time
by pressing .
C
You can determine which type of local BT
exchange you are connected to using the
following procedure.
1 Ensure that the dialling mode is selected
tone.
2 Press , then identify the dial tone.
3 Dial a number you are familiar with.
4 If the call is successful, you are
connected to a tone exchange.
Therefore, leave the dialling mode as
tone.
5 If the call is not successful, you are
connected to pulse exchange.
Therefore, set the dialling mode to pulse.
Ex.Tone is selected.
Input Command
3
----
Input Command
31 1
KX-TCD955EC(008~015) 99.6.16 5:23 PM Page 13