Operating instructions

19
Chapter 2
Basic Operations
1 Enter a phone number.
• The entered number is displayed.
• If you misdial, press . Digits are
erased from the right.
• To cancel, press firmly.
2 Press .
• After a few seconds, the display will start
showing the length of the call.
3 To hang up, press or place the
handset on the base unit.
• The handset will return to the stand-by
mode.
C
C
Making Calls
1 Press .
2 Dial a phone number.
• The dialled number is displayed.
• After a few seconds, the display will start
showing the length of the call.
• If “ ” flashes and an alarm tone sounds
after pressing , move closer to the
base unit. Then try again.
• If busy tones sound after pressing to
make a call, the base unit speakerphone or
another handset is in use.
• You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 38).
3 To hang up, press or place the
handset on the base unit.
• The handset will return to the stand-by
mode.
Make sure that the power is ON (p. 14).
i2345678
888800-00-00
To dial after confirming
the entered number
With the Handset
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
F or G to select
the desired level.
• After a few seconds, the display will return to
the length of call.
OR
In the stand-by mode, proceed as follows.
1 Press .
2 Press G or F until “ F6 ” is displayed,
then press .
• The current level is displayed.
3 Press F or G to select
the desired level.
4 Press .
PROG
OK
PROG
Ex. LOW is selected.
F6
Ex. LOW is selected.
KX-TCD953EB(019~031) 4.25.2000 1:53 PM Page 19