Operating instructions

1 Press then .
2 Press then
.
• The current setting is displayed.
1: ON 0: OFF
3 To select OFF, press
.
OR
To select ON, press
.
4 Press .
• A confirmation tone sounds and the
display will return to the stand-by mode.
• To cancel during programming, press
then start from step 1.
PROG
PROG
1
0
1
2
INT
PROG
17
Chapter 1
Preparation
Setting the Key Tones
Make sure that the power is ON (p. 14) and the unit is in the stand-by mode.
1 Press .
2 Press G or F until “ F2 i ” is displayed,
then press .
• The current setting is displayed.
1: ON 0: OFF
3 Press G or F to select the desired
setting.
• You can press or to select OFF
or ON.
4 Press .
• If ON is selected, a confirmation tone
sounds. The display will return to the
stand-by mode.
PROG
1
0
OK
PROG
F2 iU i
Ex. ON is selected.
On the base unit
You can choose whether or not the base unit
keys will sound tones. The factory preset is ON.
2 iU i
Ex. ON is selected.
On the handset
You can choose whether or not the handset
keys will sound tones (key tone, confirmation
tone, error tone). The factory preset is ON.
KX-TCD953EB(008~018) 4.25.2000 1:50 PM Page 17