Operating instructions

SMS (Short Message Service)
35
L To erase all messages, select “Erase
All”, then press ,.
3 Select “Yes”, then press ,.
4 Press {ih}.
Storing the sender’s number in
the phonebook
1
While reading a received message,
press $ (middle soft key).
2 Select “Add Phonebook”, then press
,.
3 Continue from step 3, “Adding entries to
the phonebook”, page 16.
Editing the sender’s number
before calling back
1
While reading a received message,
press $ (middle soft key).
2 Select “Edit and Call”, then press
,.
3 Edit the number, then press {C}, {s},
or , to call.
Guide to SMS settings
If the base unit is reset to its default settings
(page 29), the following SMS-related
settings will be reset.
Note:
L If the base unit is reset to its default
settings, the contents of the receive and
send lists will be erased.
Storing the PBX line access
number (for PBX users only)
Store your PBX line access number (4 digits
max.) so that SMS messages are sent
properly. When sending SMS messages to
entries in the phonebook or redial list, the
PBX line access number will be deleted.
1 Press $ (middle soft key).
2 Select X, then press ,.
3 Select “Settings”, then press ,.
4 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
29).
5 Select “PBX Access No.”, then press
,.
6 Select “On”, then press ,.
7 Enter your PBX line access code and a
dialling pause, if necessary, then press
, 2 times.
8 Press {ih}.
SMS settings Default
setting
Page
SMS on/off Off page 32
Message
Centre 1
— page 32
Message
Centre 2
— page 32
PBX line
access number
Off page 35
TCD300CX(e).book Page 35 Monday, January 31, 2005 1:49 PM