Operating instructions

Base Unit Settings
27
4 Select “Ringer Setup”, then press
,.
5 Select “Night Mode”, then press
,.
6 Select “Ring Delay”, then press
,.
7 Select the desired setting, then press
,.
8 Press {ih}.
Call options
Setting dialling mode
(tone/pulse)
“Tone”: Select when you have a touch tone
service.
“Pulse”: Select when you have rotary or
pulse service.
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4 Select “Call Options”, then press
,.
5 Select “Dial Mode”, then press ,.
6 Select the desired setting, then press
,.
7 Press {ih}.
Changing the flash time
Change the flash time, if necessary,
depending on the requirements of your
service provider or PBX.
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4 Select “Call Options”, then press
,.
5 Select “Recall”, then press ,.
6 Select the desired setting, then press
,.
7 Press {ih}.
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your
service provider or PBX.
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4 Select “Call Options”, then press
,.
5 Select “Pause Length”, then press
,.
6 Select the desired setting, then press
,.
7 Press {ih}.
Storing/changing emergency
numbers
These settings determine which phone
numbers can be dialled while the call bar
feature is on (page 23).
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4 Select “Call Options”, then press
,.
5 Select “Emergency No.”, then press
,.
6 Select a memory location, then press
,.
TCD300CX(e).book Page 27 Monday, January 31, 2005 1:49 PM