User guide

7
1 Lift the handset and press {ih} to put the handset in standby mode.
2 Press and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds.
3 Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and
w stops flashing.
Note:
• If an error tone sounds, or if w is still flashing, register the handset
manually. (See manual registration in the KX-TCD300/KX-TCD320/KX-
TCD340 operating instructions.)
• If all registered handsets start ringing in step 2, press {x} to stop. Start
again from step 1.
• Charge the batteries for about 7 hours before initial use.
• The KX-TCD300 does not feature an answering system.
• Answering system features are available only when this handset is
registered to the KX-TCD320/KX-TCD340.
TCA130FX(EX).book Page 7 Wednesday, April 20, 2005 3:10 PM