Operating instructions

44
Setting up the Printer
4
Connect the other end of the parallel interface cable into the appropriate
parallel connector on your computer and tighten the screw.
NOTE
• The actual connector on the computer may differ depending on the manufacturer of the computer.
If you use KX-P7510 or KX-P7500 with the installed optional network card KX-PNB2, you can
connect your printer to an Ethernet 10/100 Base-T network.
NOTE
• Use Category 5 shielded twisted pair cable with RJ-45 connector.
1
Make sure the printer and the computer are turned off.
2
Connect a shielded twisted pair network cable to the RJ-45 port on the rear
of the printer.
Using a network cable
MIDI/GAME PHONE LINE
LINE
OUT
LINE
IN
RJ-45 port