Operating instructions

151

Options

The following section explains how to install a Network Card for Ethernet (KX-PNB2) on the KX-

P7500.

To install the network card you will need to perform the following:

• Remove the printer cover from the right of the printer. See page 136.

• Install the network card on the printer controller board.

• Replace the printer cover. See page 140.

• Conﬁgure the printer’s network setup. See Network card’s Quick Installation Guide included in the

KX-PNB2.

IMPORTANT

• To prevent static electricity damage to certain components (see page 136), touch a grounded

metal surface, such as the printer’s bare metal frame prior to touching the component.

• Network Card for Ethernet (KX-PNB2)

CAUTION

• Do not drop or bend the network card.

• Do not touch the connector of the network card.

• Protect the network card from static electricity by keeping it in its anti-static package until you are

ready to install it.

• Avoid exposing the network card to direct sunlight, high temperatures, or humidity.

Installing a Network Card for Ethernet

Kit contents

Network Card for Ethernet