Operating instructions

Relative Direction
Setting:
DR run,rise(;)
or
DR(;)
Parameter : run rise
Format : clamped real clamped real
Range : -32768 to 32767 -32768 to 32767
Default : 1% of P2X-P1X 0
This command sets the direction in which labeling is performed relative to the
scaling points P1 and P2.
The printer resets the label direction to relative and horizontal (default) if no
parameters are entered.
• Run
Specifies the relative distance to the horizontal direction as a percentage.
The distance is indicated by the (P2X − P1X) × run(%).
• Rise
Specifies the relative distance to the vertical direction as a percentage.
The distance is indicated by the (P2Y − P1Y) × rise(%).
You can specify the label direction using the run and rise parameters.
Refer to Figure 3.66 to see how the label direction is determined by the (+) or (-)
sign.