Operating Instructions
Table Of Contents
- Important Information
- Table of Contents
- Introduction and Installation
- Preparation
- Printer
- Scanner
- Copier
- Fax (KX-MB771 only)
- Sending Faxes
- Receiving Faxes
- 6.6 Selecting the way to use your fax machine
- 6.7 Receiving a fax automatically – Auto answer ON
- 6.8 Receiving a fax manually – Auto answer OFF
- 6.9 Using the unit with an answering machine
- 6.10 Receive polling (retrieving a fax placed on another fax machine)
- 6.11 Junk fax prohibitor (preventing fax reception from undesired callers)
- 6.12 Receiving a fax into your computer
- Caller ID (KX-MB771 only)
- Programmable Features
- Useful Information
- Help
- Paper Jams
- Cleaning
- General Information
- Index

2. Preparation
16
Document Requirement s
2.3 Setting the original
2.3.1 Using the scanner glass
1
Open the document cover (1).
2 Place the document FACE DOWN on the scanner
glass (2), aligning the top left of the document with
the corner to which the m mark points.
3 Close the document cover.
Note:
L Confirm that there are no documents in the auto
document feeder (KX-MB771 only).
L Place the original onto the scanner glass gently and
do not press down too firmly to avoid malfunction.
L If the original is a thick book, do not close the
document cover.
L Check that ink, paste or correction fluid has dried
completely.
L Effective scanning area is as follows:
Effective scanning area
L Shaded area will be scanned.
2.3.2 Using the auto document feeder (KX-
MB771 only)
1
Insert the document (up to 20 pages) FACE UP into
the feeder until a single beep is heard.
2 Adjust the width of the document guides (1) to fit
the actual size of the document.
Note:
L Confirm that there are no documents on the scanner
glass.
L Check that ink, paste or correction fluid has dried
completely.
L Remove clips, staples or other fasteners.
L Do not set the following types of documents when:
(Make a copy of the document using the scanner
glass and set the copy instead.)
– Chemically treated paper such as carbon or
carbonless duplicating paper
– Electrostatically charged paper
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
be seen through the other side, such as
newsprint
L The total height of the documents when laid flat,
must be less than 4 mm. If the documents exceed the
capacity of the auto document feeder, they may fall or
cause a jam in the feeder.
L To set a document with a width of less than 210 mm,
we recommend using the scanner glass to copy the
original document onto A4 or letter-sized paper, then
setting the copied document.
L Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
L Available document size, document weight and
effective scanning area are as follows:
1
2
208 mm
287
mm
5 mm
5 mm
4 mm
4 mm
1
MB261_771E-PFQX2753ZA-OI-en.book Page 16 Monday, June 25, 2007 2:47 PM










